"The 1920 is a 1 MHz LCR Meter from Quadtech. An LCR meter is a piece of electronic test equipment that measures inductance (L), capacitance (C), and resistance (R) of electronic components. The LCR meter accurately measures these elements on an electronic device, usually one subjected to an alternating current (AC) voltage source. The LCR meter measures the current through and voltage across the device under test.","Additional Features:","Specifications","Test Frequency: ","Measurement Speed:","Ranging: ","Trigger:","Source Impedance: ","AC Test Signal: ","DC Bias Voltage: ","Display: ","Results Formats: ","Sequencing: ","Standard Interfaces:","Measurement Delay:","Averaging: ","Median Value: ","Setup Storage: ","Other: ","Calibration: ","Usage & Cal Data: ","Self Test: ","Test Terminals: ","Mechanical: ","Dimensions:","Environmental: ","Power: ","Applications","The 1920 is a high performance LCR Meter designed to perform fast, automated impedance measurements on a variety of electronic components and materials. The instrument has a basic accuracy specification of 0.1% for accurate test results over a wide frequency range, from 20 Hz to 1 MHz. Besides 15 impedance parameters the 1920 is also capable of measuring DC resistance as well as monitoring the voltage across or current through the device under test. The unit incorporates a distinctive sequence test mode, allowing up to 6 uniquely different tests to be performed quickly on a single start command. Additionally, the 1920 includes IEEE-488, RS-232, and handler interfaces, all standard.","20 Measurement ParametersMeasure and display any two of 15 impedance parameters simultaneously, with a basic accuracy of 0.1%. Additionally, the 1920 can measure the DC resistance, or display the current through or voltage across a test device ensuring the operator of the real test conditions.","Wide FrequencyOver 27,000 user programmable test frequencies to fully characterize devices over the range of 20 Hz to 1 MHz.","Automatic Test SequencingFor increased productivity and throughput the 1920 can perform up to six different tests in sequence with a single push of the start button. Each test can have different measurement parameters, test conditions and limits.","DC Bias VoltageThe instruments internal DC bias voltage source, programmable from 0 to 2 V in 1 mV steps, allows capacitors to be tested under real DC bias conditions.","Setup Storage\/RecallThe test operator has the ability to store and recall, from internal memory, up to 30 single test setups and 10 sequential setups (six tests in sequence). The front panel can be locked out, with password protection, to ensure that procedures are run the same way every time.","Load CorrectionSubstantially improves instrument accuracy by allowing the operator to specify the value of a known standard, measure it, and apply a correction to ongoing measurements.","Programmable Source ImpedanceThe operator is able to set instrument source impedance at 5, 25, 50 or 100 ohms, an important feature when comparing measurements to those made on other testers. Measurement results can vary substantially based solely on the source impedance of the tester being used."