TMP Pro Distribution 37971 混音器和控制台

"The A-16II allows individual performers to create custom monitor mixes tailored to their individual needs. Designed for use in live performance or in the studio, the A-16II Personal Mixer gives each performer control over channel volume, grouping, pan, stereo spread, and master volume and tone. Every Personal Mixer in a system can create a unique monitor mix for a performer. Users can save and recall up to sixteen custom mixes as presets in their Personal Mixer. Stereo output for wired or wireless The stereo output from the A-16II can be used to drive wired or wireless in-the-ear monitors, headphones, powered floor wedges, an amplifier, or spot monitors. The A-16II Personal Mixer is fully compatible with all Pro16® Series products, including Aviom's digital interface card for Yamaha® digital mixing consoles. Support for Aviom monitor mixing is available in the form of console interface cards from an ever- increasing list of digital console manufacturers including Digidesign®, Soundcraft®, Innovason®, etc. Daisy-chain and power Mixers can be daisy-chained or connected in parallel using an A-Net Distributor. Parallel connections also allow power to be supplied to the mixers over the Cat-5e cable. As with all Pro16 Series products, Cat-5e cable runs of up to 500 feet (150 meters) are possible between devices, and there is no limit to the number of mixers in a system.Audio Output: 1\/4-inch TRS stereo, headphone or line level Line\/Headphone TRS Output: Tip: Audio Left; Ring: Audio Right;Sleeve: Ground Auto-detects mono plugs A-Net Input\/Output: 1 A-Net input, 1 A-Net output; Category 5 (RJ45 connector) Digital to Analog Conversion Bit Depth: 24 bit Signal to Noise Ratio: (Referenced to 0dB) -103dB Latency: <0.880 msec (measured from analog input to analog output) Pro16 A-Net: uses unshielded Cat-5e UTP (or better) cable; maximum 500ft (150m) between devices Tone Controls: Treble +\/-12dB at 9kHz shelving Bass +\/-12dB at 160Hz shelving Maximum Levels (RMS): Line\/Headphone outs: 1.0 watt at 100 ohms Impedance: Line\/Headphone outs: 32 ohms Dimensions: 10.75\" (273 mm) wide x 5.6\" (142.2 mm) deep; 2.25\" (57.5 mm) high Weight: 3.4 lbs. (1.54 kg) Options: MT-1 Mic Stand Mount (uses 6-32 1\/4-inch screws) EB-1 Extension Bracket MT-X Expansion Box (requires MT-1)"